RMAUT04 Autoflow Reduce Guard to Floor Height

Modification to reduce the guard to floor height <180mm

Compliance RMAUT04_Autoflow_Reduce_Guard_to_Floor_Height_Image2.png

To comply with BS EN ISO 13857 the gap below a guard must be less than 180mm to prevent access for the whole body.

The guards on the Autoflow guarding are fastened in a slot and can be simply adjusted to reduce this height.

This change will reduce the height of the guard, however this will still give an overall height of at least 1800mm.

According to BS EN ISO 13857, section 4.2.2.2, Table 1 (assuming slight injury and low severity),

Hazard Height = 1400mm, safe distance to hazard 100mm. In this case the hazard is 500mm away en none 0

Draft