Swapping a Beckhoff PC on an machine with EL6070 Licence Slice installed
Difficulté
Très facile
Durée
5 minute(s)
Sommaire
- 1 Introduction
- 2 Étape 1 - Power Off
- 3 Étape 2 - Pop the retaining clips for the PC
- 4 Étape 3 - Remove the network cables
- 5 Étape 4 - Remove the power cables
- 6 Étape 5 - Pull the Orange Retaining clip
- 7 Étape 6 - Swap the PCs
- 8 Étape 7 - Reattach Power Cables
- 9 Étape 8 - Replace Network Cables
- 10 Commentaires
Introduction
If a machine is set up with an EL6070 Licence Slice, the PLC can be swapped freely and the TwinCAT licence remains on the slice in the machine
Étape 1 - Power Off
Étape 2 - Pop the retaining clips for the PC
There are a row of retaining clips on bot the top and bottom of the PC that hold it to the Din rail.
Pop them open with a flathead screwdriver
Étape 3 - Remove the network cables
Étape 4 - Remove the power cables
On the right hand side of the PC there are a 2 columns of yellow, white and earth power cables. All must be removed using a small flathead screwdriver to release the friction clamps on the cables
Étape 5 - Pull the Orange Retaining clip
This clip is the final fastening to the din rail
Étape 6 - Swap the PCs
Étape 7 - Reattach Power Cables
Yellow into + / 24v
White into - / 0v
G/Y into PE
Étape 8 - Replace Network Cables
Yellow in top
Green in Bottom
Draft
Français
English
Deutsch
Español
Italiano
Português