PC Recovery Process

How to recover P.C following a system failure, using the USB recovery stick.

Difficulté

Easy Facile

Durée

15 minute(s) minute(s)

recovery, dell, image Dell Optiplex 3080.jpg

Introduction

The PCs are now shipped with a memory stick that includes a full recovery image. If the system fails in future, this allows a full recovery of the initial setup of the entire drive.

Mouse and Keyboard are required for recovery process.

Étape 1 - Boot selection screen

- Turn off the PC

- Plug in recovery USB.

- Turn the PC back on

- Keep pressing F12 until the boot selection screen shows.

Étape 2 - Selecting Recovery image.

- Select "UEFI: USB".

- Once the recovery software has finished loading, make sure the "Restore" tab is selected from the top left.

- Click "Browse for an image file..."

- Select the "RecoveryImage" partition.

- Select the .mrimg file and click "OK"

Étape 3 - Restore Image

- Select "Restore Image" on the right side.

- On the Restore Summary page, click "Finish".

- Tick the "All target data will be overwritten. Confirm to proceed" box and click continue.

- Wait for the restore process to complete.

Étape 4 - Completion

- Once completion is prompted, removed the USB drive.

- Click "File" and then Exit.

- The CNC machine should now reboot and boot into Windows.

Étape 5 - Install teamviewer

Étape 6 - Contact Stuga

The PC has been set to factory default, and will need a backup installed. Contact Stuga

en none 0 Draft