ZX5 Transfer Table Crank set up

How to set up the cranks mechanically so the correct overlaps and limits are achieved.

Difficulté

Medium Moyen

Durée

30 minute(s) minute(s)

zx5, Transfer Table, Transfer, Crank ZX5_Transfer_Table_Crank_set_up_20201021_134140.jpg

Introduction

This tutorial will show you how to mechanically set up the cranks and sensors so that the correct overlaps between the different cranks are achieved.

• Pièces et outils

Pièces et outils

[[Item:|]] A fatal error occurred in the #info parser function

Étape 1 - Programme Eaton Drives.

Follow the instructions in this tutorial.

...It is vital that the Eaton drives are programmed correctly as the distance the cranks travel and the time they take to stop depend on the acceleration and deceleration of the drive.

...Programming the drives after the mechanical set up may lead to crashes. Ensure this is done first.

Étape 2 - Set idler and tighten clutches

1. Loosen the two bolts holding the idler
2. Adjust until the idler sprocket is applying some pressure to the chain
3. Use a C spanner or a hammer and drift to tighten the clutch.

...Don't lock the clutch in place with the tabs until you're sure the correct tension has been achieved

en none 0 Draft