Using a NetSetGo disk to reformat an ACEpc hard drive and install all the correct software to enable IP address networking
Difficulté
Très facile
Durée
5 minute(s)
Introduction
This procedure will completely overwrite any data on the hard drive of the ACEpc.
This is not a problem on a flowline where the data resides on the main MH hard drive in a shared directory c:\saw.
If this process is to be carried out on a standalone saw or router, make sure the data is backed up first.
- Pièces et outils
Pièces et outils
NetSetGo Floppy Disk 
Disk for reformatting ACEpc
Étape 1 - Insert disk (Power off)
Power off the machine and insert the NetSetGo disk
Étape 2 - Power On
Switching on with the floppy disk in will boot from the floppy drive instead of the hard drive
Étape 3 - Format Hard Drive and copy Zip
The PC will boot from the floppy disk and you will be prompted
Proceed with format
Press Y
You will then be prompted
Volume label [enter]
Press Enter
This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.
Étape 4 - Run NetEdit from command prompt
Follow the procedure for Setting IP address using NetEdit
Draft
Français
English
Deutsch
Español
Italiano
Português