How to set ultrasonic sensor to detect profile
Difficulté
Facile
Durée
2 minute(s)
Introduction
How to set up an ultrasonic sensor when it is mounted vertically. This is normally the case on ZX5 machines on the "Mod_Clear" functions near the rollers.
Vimeo
Utiliser la passerelle
Étape 1 - Ensure there is 30mm clearance from sensor to profile
If the sensor is closer than 30mm, it will not work
Étape 2 - Press button with profile in place
Hold button in until yellow and green lights flash, let go
Étape 3 - Press Button with profile removed
This sets the longest range of the sensor.
Hold until flashing stops
Étape 4 - Check that it works
Light will come on when object is detected
Draft
Français
English
Deutsch
Español
Italiano
Português