Training Laser on Ecoline

The laser on an Ecoline needs to be specially set up to measure the profile accurately

Difficulté

Medium Moyen

Durée

10 minute(s) minute(s)

ecoline, laser, accuracy, focus Item-Laser_Focusing_Spanner_IMG_1269.jpg

Introduction

The laser needs to be focused on the work area and not the receiver

The smaller the dot for the profile to break/make the more accurate the laser

• Pièces et outils

Pièces et outils

Laser Focusing Spanner

9mm spanner supplied with B0000360

Laser Focusing Spanner

Étape 1 - Remove the lower guard access plate

Étape 2 - Remove the laser dust cover

Étape 3 - Focus

Place a clean, white profile or sheet of paper in the clamps and adjust the Y axis position so the laser dot can be seen below it

Focus the laser to make the dot as small as possible on the base of the profile

Étape 4 - Sensitivity

Finally the laser receiver sensitivity needs to be checked. Unscrew the adjusting screw (AntiClockwise) until the GREEN Led goes RED. .

Then turn screw (Clockwise) until RED Led goes back to GREEN then turn a further 5 full turns the same way, the receiver sensitivity is now set

Étape 5 - Replace Dust cover

Étape 6 - Replace lower guard

en none 0 Draft