R0019264 Autoflow Mk 4,1 Infeed Safe moving equipment

Moving equipment for Infeed Frame of Autoflow Mk4.1

Difficulté

Hard Difficile

Durée

1 hour(s) heure(s)

R0019264_Autoflow_Mk_4_1_Infeed_Safe_moving_equipment_Screenshot_2025-03-10_082255.png

Introduction

<translate>Due to unbalanced nature of Autoflow 4.1 infeed frame, The following Guidance is for use of supplied parts within Assembly R0019264 for allowing safe movement of Infeed frame

Component List

D0016472	Moving U Channel for 80mm box	2
D0016498	Moving channel Support Strap	2
D0016504	Wheel Cross Member Assembled	1
D0016501	Locking Pin for U channel	2
D0016473	80mm box section clamp	2
D0016499	Lift Support Spacer	2
F0000510	M20 FORM A WASHER BZP	16
F0000200	M20 FULL NUT S/S	8
F0000567	M10 x 16 SKT CAP SCREW S/S	4
F0000060	M10 F/A Form Washer	4
M0001268	R Clip for 20mm shaft	2
F0000624	M20 x 200  Set Bolt	8
D0016506	Autoflow Mk4.Non slip pad	4

Étape 1 - Non Slip Pads

D0016506 non slip pads must be used in all applications

They should be placed between both clamping faces in all configurations of lifting.

These will provide prevention of slip and product damage

Étape 2 - Assembly details

2 off Assemblies should be configured as shown

Use compone1nts

D0016472	Moving U Channel for 80mm box	2
D0016498	Moving channel Support Strap	2

2

D0016473

80mm box section clamp

2

3

F0000510	M20 FORM A WASHER BZP	16
F0000200	M20 FULL NUT S/S	8
F0000567	M10 x 16 SKT CAP SCREW S/S	4
F0000060	M10 F/A Form Washer	4

4

F0000624	M20 x 200  Set Bolt	8
D0016506	Autoflow Mk4.Non slip pad	4

Étape 3 - Configuration One

High Lift Point can be configured as shown using the above assemblies

Large spread lifting tines are required to meet pitching of lifting channels

1 Always ensure non slip pads are fitted

2 Support strap D0016498 must be fitted as shown and secured with M10 socket caps and A form washers

en none 0 Draft