Moving equipment for Infeed Frame of Autoflow Mk4.1
Difficulté
Difficile
Durée
1 heure(s)
Introduction
Due to unbalanced nature of Autoflow 4.1 infeed frame, The following Guidance is for use of supplied parts within Assembly R0019264 for allowing safe movement of Infeed frame
Component List
| D0016472 | Moving U Channel for 80mm box | 2 |
| D0016498 | Moving channel Support Strap | 2 |
| D0016504 | Wheel Cross Member Assembled | 1 |
| D0016501 | Locking Pin for U channel | 2 |
| D0016473 | 80mm box section clamp | 2 |
| D0016499 | Lift Support Spacer | 2 |
| F0000510 | M20 FORM A WASHER BZP | 16 |
| F0000200 | M20 FULL NUT S/S | 8 |
| F0000567 | M10 x 16 SKT CAP SCREW S/S | 4 |
| F0000060 | M10 F/A Form Washer | 4 |
| M0001268 | R Clip for 20mm shaft | 2 |
| F0000624 | M20 x 200 Set Bolt | 8 |
| D0016506 | Autoflow Mk4.Non slip pad | 4 |
Étape 1 - Non Slip Pads
D0016506 non slip pads must be used in all applications
They should be placed between both clamping faces in all configurations of lifting.
These will provide prevention of slip and product damage
Draft
Français
English
Deutsch
Español
Italiano
Português