B0000025 B0001175 Belt Identification

Guide to correct identification of appropriate Saw blade motor drive belts

Difficulté

Easy Facile

Durée

5 minute(s) minute(s)

Saw, Blade, belts, Motor, pulley Saw_Motor_Drive_Belt_Identification_Guide_Screenshot_2025-02-06_134808.png

Introduction

A Guide to correctly identify the variant of drive belt required for ZX5, ZX4 ,ZX3 S-65 and Flowline saw modules

Belts will vary across blade sizes and Pully diameters

Key indicator is pulley size, over blade size

Étape 1 - Pulley Size

Pulley size must be measured to determine the correct belt size for the machine

There are 2 sizes of pulley that may be fitted

A tape measure will be adequate for taking a measurement

Étape 2 - How to measure

Simply use the tape measure to take measurement over the indicated area, don't be too fussy, as the difference in pulley sizes is very noticeable

Étape 3 - Measure

Measure the 2 indicated pulleys

Étape 4 - Results

Use your measurements below to calculate the correct Stuga Part number required for replacement belts

IF 1 pulley measures around 84mm( 8.4cm ) and the other pulley measures around 104mm (10.4cm), the machine will require B0000025 drive belts

If both pulleys measure the same at around 84mm (8.4cm) , then the machine will require B0001175 drive belts

If your pulleys both measure around 104mm (10.4cm), Please raise this with our technical team immediately

en none 0 Draft