Setting an ultrasonic sensor mounted vertically
Difficulté
Facile
Durée
5 minute(s)
Sommaire
- 1 Introduction
- 2 Video d'introduction
- 3 Étape 1 - Ensure there is 30mm clearance from sensor to profile
- 4 Étape 2 - Place Profile at minimum position
- 5 Étape 3 - Press and hold button until lights flash
- 6 Étape 4 - Place profile at maximum position
- 7 Étape 5 - Press and hold until lights stop flashing
- 8 Étape 6 - Test with profile
- 9 Commentaires
Introduction
This involves setting a "window" for a minimum and maximum range when mounted horizontally
Vimeo
Étape 1 - Ensure there is 30mm clearance from sensor to profile
The sensor will not work unless there is 30mm clearance to minimum position
Étape 2 - Place Profile at minimum position
Usually with profile against backfence
Étape 3 - Press and hold button until lights flash
Around 3 seconds
Étape 4 - Place profile at maximum position
On an Ecoline, around 60mm
Étape 5 - Press and hold until lights stop flashing
Étape 6 - Test with profile
Ensure it turns off and on in the set window
Draft
Français
English
Deutsch
Español
Italiano
Português