R0008013 Clacker assembly

Auteur avatarGareth Green | Dernière modification 9/11/2023 par Gareth Green en cours de rédaction

Introduction

Tools Required


10mm spanner

5mm punch

Ball pein hammer


Parts Required


D0008339 Gap Closer Arm x 1

D0008340 Gap Closer Base x 1

D0008496 Clacker Pins x 1

M0000101 Compression Spring 11 D 15 D 25 Long x1

F0000185 M6 x 16 Hex set S/S x 1



Étape 1 - M000101 Compression spring

M0000101 is not required for bench assembly , and will not be shown within the work instruction .


Ensure this part is issued with each assembled clacker



Étape 2 - Components

D0008339 Gap Closer Arm x 1

D0008340 Gap Closer Base x 1

D0008496 Clacker Pins x 1

F0000185 M6 x 16 Hex set S/S x 1



Étape 3 - Fit D0008496 Clacker Pins

Use ball pein hammer to locate D0008496 Clacker Pins into D0008340 Gap Closer Base as shown


Ensure pin does not go past indicated face



Étape 4 - Position D0008339 Gap Closer Arm

Position D0008339 Gap Closer Arm as shown


...It is vital to orientate this part correctly . Note the offset between the arm and base when orientated correctly


Étape 5 - Drive in pin

Drive pin through parts until flush with face



Étape 6 - Centralise pin

Use a 5mm punch and ball pein hammer to centralise pin between the 2 outer faces of D0008340 Gap Closer Base


Étape 7 - Fit stop

...F0000185 M6 x 16 Hex set S/S bolt is used as a stop .It is vital that this part is not set any further into the assembly than described in the steps below


Position assembly as shown


Fit M6 set bolt by hand


Slowly adjust set bolt by winding into the assembly until the shown position is achieved by the base and arm when Head of set bolt contacts the clacker base


DO NOT SET ANY FURTHER THAN THIS POSITION


Étape 8 - Finish

Check list


Pin centralised

Set bolt adjusted

Clacker arm and base pivots on pin by hand


Commentaires

Draft