R0008013 Clacker assembly

Assembly details for clacker assembly

Difficulté

Easy Facile

Durée

5 minute(s) minute(s)

R0008013_Clacker_assembly_IMG_6073.JPG

Introduction

Tools Required

10mm spanner

5mm punch

Ball pein hammer

Parts Required

D0008339 Gap Closer Arm x 1

D0008340 Gap Closer Base x 1

D0008496 Clacker Pins x 1

M0000101 Compression Spring 11 D 15 D 25 Long x1

F0000185 M6 x 16 Hex set S/S x 1

Étape 1 - M000101 Compression spring

M0000101 is not required for bench assembly , and will not be shown within the work instruction .

Ensure this part is issued with each assembled clacker

Étape 2 - Components

D0008339 Gap Closer Arm x 1

D0008340 Gap Closer Base x 1

D0008496 Clacker Pins x 1

F0000185 M6 x 16 Hex set S/S x 1

Étape 3 - Fit D0008496 Clacker Pins

Use ball pein hammer to locate D0008496 Clacker Pins into D0008340 Gap Closer Base as shown

Ensure pin does not go past indicated face

Étape 4 - Position D0008339 Gap Closer Arm

Position D0008339 Gap Closer Arm as shown

...It is vital to orientate this part correctly . Note the offset between the arm and base when orientated correctly

Étape 5 - Drive in pin

Drive pin through parts until flush with face

Étape 6 - Centralise pin

Use a 5mm punch and ball pein hammer to centralise pin between the 2 outer faces of D0008340 Gap Closer Base

Étape 7 - Fit stop

...F0000185 M6 x 16 Hex set S/S bolt is used as a stop .It is vital that this part is not set any further into the assembly than described in the steps below

Position assembly as shown

Fit M6 set bolt by hand

Slowly adjust set bolt by winding into the assembly until the shown position is achieved by the base and arm when Head of set bolt contacts the clacker base

DO NOT SET ANY FURTHER THAN THIS POSITION

Étape 8 - Finish

Check list

Pin centralised

Set bolt adjusted

Clacker arm and base pivots on pin by hand

en none 0 Draft