Fitting instructions for waste chutes
Difficulté
Moyen
Durée
1 heure(s)
Sommaire
- 1 Introduction
- 2 Étape 1 - Unless otherwise stated
- 3 Étape 2 - Fit lower chute lip
- 4 Étape 3 - Fit side chutes
- 5 Étape 4 - Fit swarf chute section one
- 6 Étape 5 - Fit cylinder poscket
- 7 Étape 6 - Fit chute section 2
- 8 Étape 7 - Position for best fit
- 9 Étape 8 - Finalise all fasteners
- 10 Étape 9 - Connect Chute blower feed pipes
- 11 Étape 10 - Connect Y3501 and Y3502
- 12 Étape 11 - Loom feed pipes to top clamp
- 13 Commentaires
Introduction
Tools Required
Standard Hex key set
Pipe cutters
Parts Required
Étape 1 - Unless otherwise stated
Use locktite 243 on all fasteners
Use loctite 572 on all threaded pneumatic connection
Pen mark all fasteners to show finalised
Étape 2 - Fit lower chute lip
Fit lower swarf lip
Étape 3 - Fit side chutes
Fit 2 off side chutes
Do not finalise fasteners
Étape 4 - Fit swarf chute section one
Fit larger swarf chute section
Do not finalise fasteners
Étape 5 - Fit cylinder poscket
Fit cylinder pocket
Do not finalise fasteners
Étape 6 - Fit chute section 2
Fit chute section 2
Do not finalise fasteners
Étape 7 - Position for best fit
Position all sections in conjunction with each other for best fit
Étape 8 - Finalise all fasteners
Finalise all fasteners ensuring adhesive is applied
Étape 9 - Connect Chute blower feed pipes
Connect 2 off 6mm black air pipes to bulkheads for chute blowers on rear of swarf chutes
Étape 10 - Connect Y3501 and Y3502
Connect 3502 and 3501 6mm pipes to rear of chute and insert x63 reed switch through grommit
Étape 11 - Loom feed pipes to top clamp
Set position of reed switch on top clamp cylinder using test box
Loom and spiral wrap pipes and reed switch and restrain
Draft
Français
English
Deutsch
Español
Italiano
Português