R0015358 Conveyor chassis

Assembly details for conveyor frame

Difficulté

Medium Moyen

Durée

4 hour(s) heure(s)

R0015358_Conveyor_chassis_Screenshot_2023-10-31_122941.png

Introduction

Tools Required

standard hex key set

Standard spanner set

Standard HSS drill set

Standard tap set

Utility knife

Parts Required

B0000441 Conveyor 3580mm x 300mm x 1

B0001013 Conveyor Motor SEW - WA 10 x 1

B0001177 Pair conveyor side cheeks and bearings slave x 2

M0000133 Conveyor Belt XL-AS 7350 x 300 B x 1

P0000200 Elbow Adaptor 6mm - M5 x 3

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Drill blower points on rollers

indicated 3 roller housings will require blower holes adding

Please include all drilling details for this procedure

Étape 3 - Assemble mounts

Assemble 4 off mounts

Each mount has 3 off maytec fittings

Ensure maytec fittings are orientated correctly

Étape 4 - insert M4 plate nuts

insert 8 off supplied m4 plate nuts into correct face of long frame sections

Étape 5 - Assemble main frame

...Ensure maytec barrel fittings are positioned on inside face

Assemble main maytec frame

Ensure all sections are set in a parallel position

Étape 6 - Finalise all fasteners

Ensure all fasteners are finalised on frame

Étape 7 - Fit Slave roller (non driven)

Fit slave roller assembly as shown

Ensure spacer washers are fitted

Ensure blower points are orientated correctly to suit belt rotation direction

Étape 8 - Fit drive roller

Fit drive roller assembly as shown

Ensure spacer washers are fitted

Ensure blower point is orientated correctly to suit belt rotation direction

Étape 9 - Attach adhesive tape

Fit supplied adhesive tape to top face of frame at shown points

Étape 10 - Fit stainless top plates

Use stainless plates as a guide to align M4 plate nuts before removing adhesive tape backing

...Ensure stainless plates are aligned correctly. They should be parallel to maytec main frame

Once aligned , remove adhesive tape backing and secure stainless plates into position

Fit 8 off supplied m4 countersunk hex sockets to finalise stainless plate fitting

Étape 11 - Fit belt

Fit belt to assembly

Étape 12 - Fit mid roller

Fit mid roller

Étape 13 - Tension slave roller

Set lower roller tension

Measure and set gap to 15mm either side

Étape 14 - Tension drive roller

Tension drive roller to provide adequate tension to belt

Ensure both sides are set tot he same measurement

Étape 15 - Check all fasteners

Quality check all fasteners

ensure all fasteners have adhesive applied, are correctly tensioned and are pen marked to indicate finalised

Étape 16 - Fit drive motor and flange

Fit drive flange to bearing cheek ensuring correct orientation to allow correct fitment of motor

Fit motor to bearing flange

Étape 17 - Fit blower fittings

Fit 3 off blower fittings to mounting points on bearing cheeks

en none 0 Draft