Stuertz Infeed - Align and dowel GX rack : Différence entre versions

[version en cours de rédaction]

Version du 7 septembre 2023 à 15:17

Align and pin main rack on Stuertz infeed

Pas encore d'image

Difficulté

Difficile

Durée

2 heure(s)

Align and pin main rack on Stuertz infeed

Difficulté

Difficile

Durée

2 heure(s)

The rack on a Stuertz infeed is a helical type and is supplied unpinned, as the motor is not connected before delivery to Stuga

The alignment must be checked then dowelled with 5mm roll pins

Using the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour

Use F

en none 0 Draft

@@ Ligne 11 : / Ligne 11 : @@
 The alignment must be checked then dowelled with 5mm roll pins</translate>
 }}
-{{Materials
+{{Materials}}
-|ItemList={{ItemList}}
-}}
 {{EPI}}
 {{Tuto Step
 |Step_Title=<translate>Align with T0001090 Tool</translate>
+|Step_Content=<translate>Using the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour
+<br /></translate>
+|Step_Picture_00=T0001090_Rack_Alignment_Tool_T0001090.jpg
+}}
+{{Tuto Step
+|Step_Title=<translate>Run GX up and down to ensure it is smooth</translate>
 |Step_Content=<translate></translate>
+}}
+{{Tuto Step
+|Step_Title=<translate>Dowel each rack one end with a 5mm roll pin</translate>
+|Step_Content=<translate>Use F</translate>
+|Step_Picture_00=Stuertz_Infeed_-_Align_and_dowel_GX_rack_F0000224.jpg
 }}
 {{Notes}}
 {{PageLang
+|Language=en
 |SourceLanguage=none
 |IsTranslation=0
-|Language=en
 }}
 {{Tuto Status
 |Complete=Draft
 }}