| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 1 : | Ligne 1 : | ||
{{Tuto Details | {{Tuto Details | ||
| + | |Main_Picture=ZX4_Infeed_Roller_Reinforcement_Annotation_2020-03-31_142909.jpg | ||
| + | |Main_Picture_annotation={"version":"2.4.6","objects":[{"type":"image","version":"2.4.6","originX":"left","originY":"top","left":-216,"top":-230,"width":534,"height":417,"fill":"rgb(0,0,0)","stroke":null,"strokeWidth":0,"strokeDashArray":null,"strokeLineCap":"butt","strokeDashOffset":0,"strokeLineJoin":"miter","strokeMiterLimit":4,"scaleX":1.85,"scaleY":1.85,"angle":0,"flipX":false,"flipY":false,"opacity":1,"shadow":null,"visible":true,"clipTo":null,"backgroundColor":"","fillRule":"nonzero","paintFirst":"fill","globalCompositeOperation":"source-over","transformMatrix":null,"skewX":0,"skewY":0,"crossOrigin":"","cropX":0,"cropY":0,"src":"https://stuga.dokit.app/images/9/91/ZX4_Infeed_Roller_Reinforcement_Annotation_2020-03-31_142909.jpg","filters":[]}],"height":449.74093264248705,"width":600} | ||
|Description=<translate>The design of the ZX4 Infeed Table was such that the first roller was located by a single block, of which was attached to the first arm by 2 bolts and a single dowel. The clearance on the two bolt holes meant that the block could rotate slightly around the dowel, resulting in the roller having a large potential deflection when load was put on it.</translate> | |Description=<translate>The design of the ZX4 Infeed Table was such that the first roller was located by a single block, of which was attached to the first arm by 2 bolts and a single dowel. The clearance on the two bolt holes meant that the block could rotate slightly around the dowel, resulting in the roller having a large potential deflection when load was put on it.</translate> | ||
|Categories=Maintenance | |Categories=Maintenance | ||
Version actuelle datée du 31 mars 2020 à 15:34
The design of the ZX4 Infeed Table was such that the first roller was located by a single block, of which was attached to the first arm by 2 bolts and a single dowel. The clearance on the two bolt holes meant that the block could rotate slightly around the dowel, resulting in the roller having a large potential deflection when load was put on it.
Difficulté
Moyen
Durée
2 heure(s)
Introduction
A plate has been designed to strengthen the installation of the first roller.
Étape 1 - Remove the 2x M8 bolts as shown.
Étape 2 - Align Infeed roller block
Align the infeed roller block so that it is square (check the roller with a straight edge against the other rollers). Fit the bracket using the 2 off M8 x 25 Bolts. Mark through the clearance holes on the bracket onto the roller block.
Étape 3 - Remove the new strengthening bracket.
Étape 4 - Drill and tap into the infeed roller block
Reinstall strengthening bracket with 2x M8 x 16 Bolts (F0000023) into the infeed roller block, and the 2x M8 x 25 Bolts (F0000025) into the infeed arm.
Étape 5 - Recheck alignment of infeed roller
Draft
Français
English
Deutsch
Español
Italiano
Português