| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 49 : | Ligne 49 : | ||
!Pulley 2 Dia | !Pulley 2 Dia | ||
!Part Number | !Part Number | ||
| − | |||
|- | |- | ||
|84mm | |84mm | ||
|104mm | |104mm | ||
|B0000025 | |B0000025 | ||
| − | |||
|- | |- | ||
|84mm | |84mm | ||
|84mm | |84mm | ||
|B0001175 | |B0001175 | ||
| − | |||
|- | |- | ||
|104mm | |104mm | ||
| − | |104mm | + | |104mm |
|Contact Stuga | |Contact Stuga | ||
| − | |||
|} | |} | ||
|Step_Picture_00=Saw_Motor_Drive_Belt_Identification_Guide_Screenshot_2025-02-06_141402.png | |Step_Picture_00=Saw_Motor_Drive_Belt_Identification_Guide_Screenshot_2025-02-06_141402.png | ||
Version actuelle datée du 6 février 2025 à 17:43
Guide to correct identification of appropriate Saw blade motor drive belts
Difficulté
Facile
Durée
5 minute(s)
Introduction
A Guide to correctly identify the variant of drive belt required for ZX5, ZX4 ,ZX3 S-65 and Flowline saw modules
Belts will vary across blade sizes and Pully diameters
Étape 1 - Pulley Size
Pulley size must be measured to determine the correct belt size for the machine
There are 2 sizes of pulley that may be fitted
A tape measure will be adequate for taking a measurement
Étape 2 - How to measure
Simply use the tape measure to take measurement over the indicated area, don't be too fussy, as the difference in pulley sizes is very noticeable
Étape 3 - Results
<translate>Use your measurements below to calculate the correct Stuga Part number required for replacement belts
| Pulley 1 Dia | Pulley 2 Dia | Part Number |
|---|---|---|
| 84mm | 104mm | B0000025 |
| 84mm | 84mm | B0001175 |
| 104mm | 104mm | Contact Stuga |
Draft
Français
English
Deutsch
Español
Italiano
Português