R0015343 Waste Guidance Installation

Installation details of waste guidance

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

R0015343_Waste_Guidance_Installation_Screenshot_2023-10-31_135102.png

Introduction

Tools Required

Standard hex key set

Standard spanner set

Standard HSS drill set

Standard tap set

Parts Required

D0001967 Conveyor End Plate x 1

D0001970 Swarf Funnel Support x 2

D0005616 Conveyor Swarf Funnel x 1

D0010843 Conveyor Deflector Plate x 1

M0000031 Panel Edging Strip; 9 x 6mm (consumable stock )

R0015344 Bench Assemble Conveyor Parts

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Please note

Drive motor must be removed to allow access to fit side sheets

1 locking grubscrew must be slackened to allow drive motor to be removed.

Ensure drive motor is refitted after installation of waste guidance sheets

Étape 3 - Fit Radius side sheets

fit 2 off radius side sheets as shown

Secure using m5 d nuts

Position as shown 5mm from edge frame

Étape 4 - Fit side sheets

Fit 4 off side sheet as shown

Étape 5 - Fit deflector

Drill and fit deflector as shown

Ensure deflector is mounted at a height that clearance is present between conveyor belt and deflector

Provide details to enable ecr to be raised to add mounting holes

Étape 6 - Position end plate

Position conveyor end plate as shown

Ensure end plate does not touch belt

Mark positions for mounting holes and remove end plate

Étape 7 - Drill end plate

Drill M6 clearance holes at marked points

Drill off cable tie bases for motor cable

Provide all details to enable ecr generation

Étape 8 - Fit end plate

Ensure button head M6 fasteners are used backed with m6 nuts

Étape 9 - Fit edging strip

Fit edging strip to top faces

please detail

Étape 10 - Fit lower swarf funnel brackets

secure with M5 caps and d nuts

Étape 11 - Add riv nuts

Add 2 off m6 rivnuts to swarf funnel

Étape 12 - Fit swarf funnel

Fit swarf funnel to conveyor brackets

Secure with M6 cap heads and washers

Picture required for correct setting position of funnel

Étape 13 - Drill and pin

Drill and pin funnel in position with 2 off 3 mm spiral pins

Étape 14 - Check all fasteners

Check all fasteners are finalised and marked

Ensure all settings have been finalised

en none 0 Draft