[version en cours de rédaction] | [version en cours de rédaction] |
(Page créée avec « {{Tuto Details |Description=<translate>Align and pin main rack on Stuertz infeed</translate> |Categories=Maintenance |Difficulty=Hard |Duration=2 |Duration-type=hour(s) }}... ») |
|||
Ligne 11 : | Ligne 11 : | ||
The alignment must be checked then dowelled with 5mm roll pins</translate> | The alignment must be checked then dowelled with 5mm roll pins</translate> | ||
}} | }} | ||
− | {{Materials | + | {{Materials}} |
− | |||
− | }} | ||
{{EPI}} | {{EPI}} | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Align with T0001090 Tool</translate> | |Step_Title=<translate>Align with T0001090 Tool</translate> | ||
+ | |Step_Content=<translate>Using the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour | ||
+ | |||
+ | <br /></translate> | ||
+ | |Step_Picture_00=T0001090_Rack_Alignment_Tool_T0001090.jpg | ||
+ | }} | ||
+ | {{Tuto Step | ||
+ | |Step_Title=<translate>Run GX up and down to ensure it is smooth</translate> | ||
|Step_Content=<translate></translate> | |Step_Content=<translate></translate> | ||
+ | }} | ||
+ | {{Tuto Step | ||
+ | |Step_Title=<translate>Dowel each rack one end with a 5mm roll pin</translate> | ||
+ | |Step_Content=<translate>Use F</translate> | ||
+ | |Step_Picture_00=Stuertz_Infeed_-_Align_and_dowel_GX_rack_F0000224.jpg | ||
}} | }} | ||
{{Notes}} | {{Notes}} | ||
{{PageLang | {{PageLang | ||
+ | |Language=en | ||
|SourceLanguage=none | |SourceLanguage=none | ||
|IsTranslation=0 | |IsTranslation=0 | ||
− | |||
}} | }} | ||
{{Tuto Status | {{Tuto Status | ||
|Complete=Draft | |Complete=Draft | ||
}} | }} |
Align and pin main rack on Stuertz infeed
Auteur Gareth Green | Dernière modification 29/09/2023 par Gareth Green en cours de rédaction ⧼frevu-button-review-label⧽
Pas encore d'image
Align and pin main rack on Stuertz infeed
The rack on a Stuertz infeed is a helical type and is supplied unpinned, as the motor is not connected before delivery to Stuga
The alignment must be checked then dowelled with 5mm roll pinsUsing the T0001090 alignment tool, check each 1m section of the rack is aligned to its neighbour
en none 0 Draft
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #