| [version en cours de rédaction] | [version en cours de rédaction] |
(Page créée avec « {{Tuto Details |Description=<translate>Notes on initial setting up of JX servo drive axis for Autoflow Mk4</translate> |Categories=Software, Specification |Tags=JX }} <tra... ») |
|||
| Ligne 4 : | Ligne 4 : | ||
|Tags=JX | |Tags=JX | ||
}} | }} | ||
| − | <translate>= Requirement = | + | <translate>=Requirement= |
| − | * Variable position for label application too difficult with cylinders | + | *Variable position for label application too difficult with cylinders |
| − | * Possibility of two labels | + | *Possibility of two labels |
| − | * Dual cylinder arrangement too slow | + | *Dual cylinder arrangement too slow |
| − | = Settings = | + | =Settings= |
| − | * Axis is JX, Axis Number 10 | + | *Axis is JX, Axis Number 10 |
| − | * Id number on A2027 is 13 | + | *Id number on A2027 is 13 |
| − | * Uses same gearbox and saddle as ZX, so scaling and parameters the same | + | *Uses same gearbox and saddle as ZX, so scaling and parameters the same |
| − | * New Parameters ejPosBladeClear, ejPosLab1, ejPosLab2, ejPosOut for servo eject positions | + | *New Parameters ejPosBladeClear, ejPosLab1, ejPosLab2, ejPosOut for servo eject positions |
| − | * ejSpeed for ejecting speed - needs to match conveyor belt | + | *ejSpeed for ejecting speed - needs to match conveyor belt |
| − | </translate> | + | |
| + | = Programming = | ||
| + | |||
| + | * Software interface internally takes the standard OuF_Eject output signal and triggers the axis movement | ||
| + | * Emulator for InF_EjectHm and InF_EjectOu | ||
| + | * Further function block to send axis to the set positions in the parameters, used in the controllers for the outfeed Unload and Apply Label cycles | ||
| + | * </translate> | ||
{{PageLang | {{PageLang | ||
| + | |Language=en | ||
|SourceLanguage=none | |SourceLanguage=none | ||
|IsTranslation=0 | |IsTranslation=0 | ||
| − | |||
}} | }} | ||
{{AddComments}} | {{AddComments}} | ||
Version actuelle datée du 9 février 2023 à 19:41
Notes on initial setting up of JX servo drive axis for Autoflow Mk4
Requirement
- Variable position for label application too difficult with cylinders
- Possibility of two labels
- Dual cylinder arrangement too slow
Settings
- Axis is JX, Axis Number 10
- Id number on A2027 is 13
- Uses same gearbox and saddle as ZX, so scaling and parameters the same
- New Parameters ejPosBladeClear, ejPosLab1, ejPosLab2, ejPosOut for servo eject positions
- ejSpeed for ejecting speed - needs to match conveyor belt
Programming
- Software interface internally takes the standard OuF_Eject output signal and triggers the axis movement
- Emulator for InF_EjectHm and InF_EjectOu
- Further function block to send axis to the set positions in the parameters, used in the controllers for the outfeed Unload and Apply Label cycles
Draft
Français
English
Deutsch
Español
Italiano
Português