Setting Infeed Datum Clamp : Différence entre versions

[version en cours de rédaction]

Version actuelle datée du 17 janvier 2023 à 12:35

Correct Setup of the Infeed Datum Clamp

Correct Setup of the Infeed Datum Clamp



1	Movement range	Make sure the Cylinder (P0001110) has a full range of movement up and down
2	Clamp Rubber Pad	The clamp should have a rubber pad (M0000253) on the bottom, ensure it is fitted and not worn
3	Locknuts Tight	Ensure the cylinder locknuts are fully tightened
4	Clamps Profiles	Place a bar in machine, Run in Setup Mode Activate Infeed side and top roller clamps Activate Infeed Datum Clamp Ensure the bar in the machine cannot be moved easily - you should have to really struggle to pull or push it in to the machining area

en none 0

Draft

@@ Ligne 23 : / Ligne 23 : @@
 |Locknuts Tight
 |Ensure the cylinder locknuts are fully tightened
+|-
+|4
+|Clamps Profiles
+|Place a bar in machine,
+Run in Setup Mode
+Activate Infeed side and top roller clamps
+Activate Infeed Datum Clamp
+Ensure the bar in the machine cannot be moved easily - you should have to really struggle to pull or push it in to the machining area
 |}</translate>
 {{PageLang
+|Language=en
 |SourceLanguage=none
 |IsTranslation=0
-|Language=en
 }}
 {{AddComments}}