[version en cours de rédaction] | [version en cours de rédaction] |
Ligne 27 : | Ligne 27 : | ||
<br /></translate> | <br /></translate> | ||
− | |Step_Picture_00=PC_Recovery_Process_Step1.jpg | + | |Step_Picture_00=PC_Recovery_Process_1.jpg |
+ | |Step_Picture_01=PC_Recovery_Process_Step1.jpg | ||
}} | }} | ||
{{Tuto Step | {{Tuto Step | ||
Ligne 53 : | Ligne 54 : | ||
|Step_Content=<translate>- Select "Restore Image" on the right side. | |Step_Content=<translate>- Select "Restore Image" on the right side. | ||
− | - On the Restore Summary page, click "Finish". | + | - On the Restore Summary page, press 'next, then click "Finish". |
- Tick the "All target data will be overwritten. Confirm to proceed" box and click continue. | - Tick the "All target data will be overwritten. Confirm to proceed" box and click continue. | ||
Ligne 67 : | Ligne 68 : | ||
{{Tuto Step | {{Tuto Step | ||
|Step_Title=<translate>Completion</translate> | |Step_Title=<translate>Completion</translate> | ||
− | |Step_Content=<translate>- Once completion is prompted, | + | |Step_Content=<translate>- Once completion is prompted, remove the USB drive. |
- Click "File" and then Exit. | - Click "File" and then Exit. |
How to recover P.C following a system failure, using the USB recovery stick.
Auteur Stuga Engineer | Dernière modification 15/03/2021 par Stuga Engineer en cours de rédaction ⧼frevu-button-review-label⧽
How to recover P.C following a system failure, using the USB recovery stick.
recovery, dell, image Dell Optiplex 3080.jpg
The PCs are now shipped with a memory stick that includes a full recovery image. If the system fails in future, this allows a full recovery of the initial setup of the entire drive.
Mouse and Keyboard are required for recovery process.- Turn off the PC
- Plug in recovery USB.
- Turn the PC back on
- Keep pressing F12 until the boot selection screen shows.
- Select "UEFI: USB".
- Once the recovery software has finished loading, make sure the "Restore" tab is selected from the top left.
- Click "Browse for an image file..."
- Select the "RecoveryImage" partition.
- Select the .mrimg file and click "OK"
- Select "Restore Image" on the right side.
- On the Restore Summary page, press 'next, then click "Finish".
- Tick the "All target data will be overwritten. Confirm to proceed" box and click continue.
- Wait for the restore process to complete.
- Once completion is prompted, remove the USB drive.
- Click "File" and then Exit.
- The CNC machine should now reboot and boot into Windows.
The PC has been set to factory default, and will need a backup installed. Contact Stuga and provide the Teamviewer ID number.
en none 0 Draft
Vous avez entré un nom de page invalide, avec un ou plusieurs caractères suivants :
< > @ ~ : * € £ ` + = / \ | [ ] { } ; ? #