| [version en cours de rédaction] | [version en cours de rédaction] |
| Ligne 39 : | Ligne 39 : | ||
=Side Clamp Positioner= | =Side Clamp Positioner= | ||
| − | *Ensure Side clamp Positioner stroke length is 100mm to give full range | + | *Side Clamp Positioner "home" position is cylinder extended. Activating the output casues the side clamp to widen to the full size |
| + | *Ensure Side clamp Positioner stroke length is 100mm to give full range of travel | ||
*Check range of motion to ensure the side clamp output can grip each profile type using the side clamp output only | *Check range of motion to ensure the side clamp output can grip each profile type using the side clamp output only | ||
Version du 2 mars 2021 à 16:55
Special guidance for setting up Ancil Saws
Tooling Design
Several Cill profile supports have already been designed.
| Build Number | Profile | Profile BMP | Cill Block |
|---|---|---|---|
| S012 | Rehau 246330 150mm
Rehau 503940 225mm |
   |
D0001897-16 Profile Support Block Infeed SH 100x16mm
D0001898-16 Profile Support Block Outfeed SH 100x16mm
|
Side Clamp Positioner
- Side Clamp Positioner "home" position is cylinder extended. Activating the output casues the side clamp to widen to the full size
- Ensure Side clamp Positioner stroke length is 100mm to give full range of travel
- Check range of motion to ensure the side clamp output can grip each profile type using the side clamp output only
Saw Stroke End Position and 500mm Upgrade
Cill saws need a 500mm blade upgrade
Check the widest profile cut at 45 degrees to ensure there is enough travel to complete the cut. to get a further 10mm stroke from the saw cut, the mount for the saw stroke cylinder rod end can be modified.
This has the downside of forcing the start point of the blade up -the blade pokes out 10mm above the slit strips, but this is not a big problem as long as the blade is not above the cut tables
Saw Stroke Mid Cut Input
Ancil saws benefit from the mid switch input on the saw stroke, because the stoke speed is inevitably slowed down on the widest profile, which also needs the full stroke range. Adding the mid point switch means narrower and lower profiles do not need the full, slow range of the cut and the cycle time is reduced considerably.
See instructions on how to set this feature up
Colour Coding Support Blocks and Pusher End
See instructions for how to set this feature up in a standard way
BladetoFence Setup
Bladetofence on an ancil saw should be around 70mm.
Cill Chute Fill Plate
Part number D0005628(-OH) is used to fill in the radius of the chute which helps offcuts of wide cills down the chute
Draft
Français
English
Deutsch
Español
Italiano
Português