| [version en cours de rédaction] | [version en cours de rédaction] |
| (7 révisions intermédiaires par 3 utilisateurs non affichées) | |||
| Ligne 32 : | Ligne 32 : | ||
|Step_Title=<translate>Power On</translate> | |Step_Title=<translate>Power On</translate> | ||
|Step_Content=<translate>Switching on with the floppy disk in will boot from the floppy drive instead of the hard drive</translate> | |Step_Content=<translate>Switching on with the floppy disk in will boot from the floppy drive instead of the hard drive</translate> | ||
| + | |Step_Picture_00=ACEpc_Installing_netedit_with_NetSetGo_disk_20190827_143006.jpg | ||
}} | }} | ||
{{Tuto Step | {{Tuto Step | ||
| Ligne 53 : | Ligne 54 : | ||
This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.</translate> | This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.</translate> | ||
| + | }} | ||
| + | {{Tuto Step | ||
| + | |Step_Title=<translate>Run NetEdit from command prompt</translate> | ||
| + | |Step_Content=<translate>Follow the procedure for [https://stuga.dokit.app/wiki/ACEpc_Changing_IP_address_using_netedit Setting IP address using NetEdit]</translate> | ||
}} | }} | ||
{{Notes}} | {{Notes}} | ||
Version actuelle datée du 25 juin 2020 à 12:57
Using a NetSetGo disk to reformat an ACEpc hard drive and install all the correct software to enable IP address networking
Difficulté
Très facile
Durée
5 minute(s)
Introduction
This procedure will completely overwrite any data on the hard drive of the ACEpc.
This is not a problem on a flowline where the data resides on the main MH hard drive in a shared directory c:\saw.
If this process is to be carried out on a standalone saw or router, make sure the data is backed up first.
- Pièces et outils
Pièces et outils
NetSetGo Floppy Disk 
Disk for reformatting ACEpc
Étape 1 - Insert disk (Power off)
Power off the machine and insert the NetSetGo disk
Étape 2 - Power On
Switching on with the floppy disk in will boot from the floppy drive instead of the hard drive
Étape 3 - Format Hard Drive and copy Zip
The PC will boot from the floppy disk and you will be prompted
Proceed with format
Press Y
You will then be prompted
Volume label [enter]
Press Enter
This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.
Étape 4 - Run NetEdit from command prompt
Follow the procedure for Setting IP address using NetEdit
Draft
Français
English
Deutsch
Español
Italiano
Português