Setting Ultrasonic Sensor - Vertical

How to set ultrasonic sensor to detect profile

Difficulté

Easy Facile

Durée

2 minute(s) minute(s)

ultrasonic, sensor, infeed, setting Setting_Ultrasonic_Sensor_on_infeed_Table_E0001120.JPG

Introduction

How to set up an ultrasonic sensor when it is mounted vertically. This is normally the case on ZX5 machines on the "Mod_Clear" functions near the rollers.

gaps  | SQ  \ MI  < AH  / IM  e ES  s mSQ m mMI a mAH i mIM f YF  r YR (Lead)
| SQ  k     j+v   w+j   j+v   t     k     j+v   w+j   j+v   k     k
\ MI  j+v   j+v   w+j   j+v   t     j+v   j+v   w+j+v j+v   j+v   j+v
> AH  k+x   j+v   j     j+v   t     k+x   j+v  	j     j+v   k+x   k+x
/ IM  j+v   j+v   w+j+v j+v   t     j+v   j+v   w+j+v j+v   j+v   j+v
e ES  k     j     j     j     0     s     s     s     s     s+s   s+s
s mSQ k     j+v   w+j   j+v   e     k     j+v   w+j   j+v   k     k
m mMI j+v   j+v   w+j   j+v   e     j+v   j+v   w+j+v j+v   j+v   j+v
a mAH k+x   j+v   j     j+v   e     k+x   j+v  	j     j+v   k+x   k+x
i mIM j+v   j+v   w+j+v j+v   e     j+v   j+v   w+j+v j+v   j+v   j+v
f YF  k     j+v   w+j   j+v   e     k     j+v   w+j   j+v   k     f
r YR  k     j+v   w+j   j+v   e     k     j+v   w+j   j+v   f     k
for version 6.63
Y notches on Ring only

Vimeo

Utiliser la passerelle

Étape 1 - Ensure there is 30mm clearance from sensor to profile

If the sensor is closer than 30mm, it will not work

Étape 2 - Press button with profile in place

Hold button in until yellow and green lights flash, let go

Étape 3 - Press Button with profile removed

This sets the longest range of the sensor.

Hold until flashing stops

Étape 4 - Check that it works

Light will come on when object is detected

en none 0 Draft