Autoflow Hepco Slewing Ring - Journal Adjustment : Différence entre versions

[en attente de relecture]

Version actuelle datée du 17 novembre 2025 à 14:34

A2024 and A2025 both have Hepco slewing rings in their Machining Rings. This document describes how to access the journals for adjustment

Difficulté

Moyen

Durée

0.5 jour(s)

A2024 and A2025 both have Hepco slewing rings in their Machining Rings. This document describes how to access the journals for adjustment

Difficulté

Moyen

Durée

0.5 jour(s)

Confluence

17/11/2025 Moved To Confluence

en none 0 Draft

@@ Ligne 17 : / Ligne 17 : @@
 {{EPI}}
 {{Tuto Step
-|Step_Title=<translate>Identify the blank spindles</translate>
+|Step_Title=<translate></translate>
-|Step_Content=<translate>Identify the blank spindles - these are the ones with no machining stations on them.</translate>
+|Step_Content=<translate></translate>
-|Step_Picture_00=Autoflow_Hepco_Slewing_Ring_-_Journal_Adjustment_Capture.JPG
-|Step_Picture_01=Autoflow_Hepco_Slewing_Ring_-_Journal_Adjustment_Capture2.JPG
-}}
-{{Tuto Step
-|Step_Title=<translate>Remove blank plates</translate>
-|Step_Content=<translate>Remove the blank plates to leave the ring as shown.</translate>
-|Step_Picture_00=Autoflow_Hepco_Slewing_Ring_-_Journal_Adjustment_Capture3.JPG
-}}
-{{Tuto Step
-|Step_Title=<translate>Remove blank plates</translate>
-|Step_Content=<translate>Remove the blank plates to leave the ring as shown. This gives access to the hole (circled red) which will rotate around over the top of each journal bolt head.
-Note that there are two of these access holes on the "doughnut ring", and they are at 180deg to each other, both under the blank spindle plates.</translate>
-|Step_Picture_00=Autoflow_Hepco_Slewing_Ring_-_Journal_Adjustment_Capture3.JPG
 }}
 {{Notes}}