R0015094 Fit shafts and Pinions

Instructions for installing main drive shafts to support arm assembly

Difficulté

Medium Moyen

Durée

3 hour(s) heure(s)

R0015094_Line_up_slider_units_and_mesh_racks_Screenshot_2023-06-13_112312.png

Introduction

Tools Required

Standard Hex key set

Grease gun and grease

Parts Required

Previously assembled parts from R0015094 Bench Assemble shafts, Bearings and Pinions

B0001100 x 24

B0001153 x 2

B0001165 x 2

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised

Étape 2 - Bearing position Clarification

1 Bearings should be located as shown on each arm

2 Grease nipples to face each other as shown

Étape 3 - Attach Bearings

1 Use 2 off M10 x 40 Countersunk bolts to centralise position of bearing block

2 Add 2 off M10 x 20 socket cap and fix in two holes indicated and tighten.

3 Replace M10 counter sunk bolts with another 2 off M10 x 20 socket caps

repeat for all bearing mounting positions

Étape 4 - Location of shafts

1 Shafts need to be correctly orientated

2 Each arm should have a key positioned as shown for drive pinions

Étape 5 - Fit shafts and pinions

1 Shafts should be slid through bearing blocks to install. Drive pinions should be added to shaft between each arm as the shaft is fitted.

2 B0001165 2 off drive sprockets will also require adding to shafts as they are fitted . See images for location

3 B0001165 should be orientated as shown

...Do not fix any pinions into position, leave floating on shafts Do not fix any bearing grubscrew lock points

Étape 6 - Couple shafts

Couple shafts together with 1 off B0001153 shaft couplers and 2 off B0001100 key per shaft

Étape 7 - Fit keys

fit 20 off keys to relevant keyways and slide 18 drive pinions and 2 off drive sprockets into approximate positions

Étape 8 - Lubrication

all bearings should be lubricated with grease gun and trojan grease

en none 0 Draft