R0015282 Fit Transfer Sliders and Set wheels

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 5/09/2024 par Gareth Green en cours de rédaction

Instructions on mounting an setting slider unit wheels correctly

Introduction

Tools Required


Standard spanner set


Parts Required


Pre built Slide units R0015281

D0015554 support arm spacer x 18

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised



Étape 2 - Fit slider units to Arms

1 Ensure drive pinion is slid away from assembly


2 Use setting dokit Setting Delrin Transfer Table Wheel Tension

and set delrin wheels to correct tension. Check at all points over oozenest V rail


3 Repeat for all 9 units



Étape 3 - Fit support arm spacers to arms

2 off per arm

Secure with M8 x 20Hex head Set bolt and finalise with Loctite 243 adhesive


Please provide photo



Commentaires

Draft