R0000570B Bench Assemble 1st stage Ejector

Cette page contient des modifications qui ne sont pas marquées pour la traduction.

Auteur avatarGareth Green | Dernière modification 16/11/2023 par Gareth Green en cours de rédaction

Bench assembly details for ejector components

Introduction

Tools Required


Standard hex key set


Parts Required


B0000033 Linear Bearing: Ø20 x 30 Compact (Metal Case Only) x 6

D0004015 Front Slider (5301) x 1

D0004016 Rear Slider x 1

D0004329 Rod End Plate (5304) x 1

D0004420 Extension Linear Block x 2

H0004630 Shaft 20mm: 345 Ejector Crossx 1


Étape 1 - Unless otherwise stated

All bolts to have Loctite 243 adhesive applied unless otherwise stated

All Threaded Pneumatic connections to have Loctite 570 applied

All bolts to be pen marked once adhesive applied and correct tension added



Étape 2 - Assemble slider blocks

D0004015 Front Slider

D0004016 Rear Slider


1 Add M6 x 6 grubscrews to indicated holes, 4 off in total. Use Loctite 572 to seal grubscrews to blocks . Ensure grubscrews sit flush with face of block when fitted. Tap hole deeper with M6 tap to allow grubscrew to sit further in if not possible to achieve flush fitment .


...Always use an airline to remove internal swarf from blocks is tapping is required


2 Fit 4 off B0000033 Linear Bearing as shown. Ensure yellow face of bearing is fitted on the indicated faces.

Ensure when fitted that no ball chamber is visible on bearings


3 Fit 4 off M6 straight grease nipples to indicated points (2 per slider) Use loctite 572 to seal


Étape 3 - Assemble Rod end plate

Insert H0004630 Shaft 20mm: 345 Ejector Cross x 1 into D0004329 Rod End Plate (5304) as shown


Dimple in shaft is offset, when correctly fitted, shaft is equally protruding either end of block


Secure with M8 x 20 kcp grubscrew, ensuring dimple is entered by the grubscrew


Étape 4 - Extension blocks

Degrease blocks before fitting bearings


Fit 2 of B0000033 Linear Bearing to 2 off D0004420 Extension Linear Block


Ensure yellow seals are facing the shown direction


Apply liberal grease to these bearings

Commentaires

Draft