WinMulti - Drives

Auteur avatarStuga Engineer | Dernière modification 16/04/2020 par Stuga Engineer en cours de rédaction

Drives

The Drives tab allows manipulation of each of the axes. Each Machine type will have different drives as shown below. The manipulation of these can only be performed in Manual Mode, to enter manual mode from the main screen press the STOP Button once.

Saw Drives


Saw Drives
Autocut Drives
Drive Description
GX Axis This is the axis for the saw pusher and works from 7060 (end if the infeed bed) to 0 (Saw Blade)
SR Axis This is the axis for the Saw Blade Rotation and works from 45 to 135 degrees


Ecoline

Flowline / ZX3 Drives

Microline

ZX4 Drives

ZX5 Drives


ZX5 Drives


Autoflow Drives

Autoflow Drives



Axes


+ / - Buttons

Once in Manual Mode tapping on the + and – buttons next to each of the drives will jog the axis in the appropriate direction, and the numbers between the +/- buttons show the current axis position.

Home

Tapping on the Home Button will move the axis back to its home position, as determined in the Settings – Axis screen.

Move & Stop

Type the position required into the Numbers between the Move and Stop buttons. When the move button is then pressed, the drive will attempt to move to the axis position given. Stop can be pressed at any point to halt this movement.

Reverse

The Reverse button reverses the direction of the associated drive.

Numbers
The Numbers after the Reverse button are (In order) Maximum Position, Speed, Acceleration, Deceleration


Inverters

The inverters section is only populated for Autoflow machines, each inverter has a Fwd and Rev button which starts the inverter going forward or backward the numbers to the right of these denote the Hertz value required for that inverter. The Stop Button will cease movement.

Speed Override

The speed override slider slows down the motor movements to give the operator time to intervene in diagnostic exercises.



Save

The Save Button saves and setting changes (e.g. Inverter frequencies)

Setup Mode

This puts the machine into setup mode.

Test Printer

This button sends a test label to the printer.

Commentaires

Draft