R0015292 Install Cylinder Rails and Align

Auteur avatarGareth Green | Dernière modification 3/04/2024 par Gareth Green en cours de rédaction

Introduction

Tools Required


Standard spanner set


Parts Required


R0015288 Bench Assemble Transfer slid units and cylinder rails

R0015093 Bench Assemble Transfer Beam

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised



Étape 2 - Position pre built cylinder rails

Position Cylinder rail onto transfer beam as shown



Étape 3 - Adjust delrin wheels front

Adjust delrin wheels on section shown


Ensure to use Setting Delrin Transfer Table Wheel Tension To set delrin wheels correctly


...Ensure M5 locking nuts are correctly tensioned when set



Étape 4 - Adjust Delrin wheels Rear

Adjust delrin wheels on section shown


Ensure to use Setting Delrin Transfer Table Wheel Tension To set delrin wheels correctly


......Ensure M5 locking nuts are correctly tensioned when set



Étape 5 - Check all fasteners

Check all fasteners are correctly tensioned


Ensure all delrin wheels are correctly set and all fasteners on delrin wheels are tensioned to final tension



Étape 6 - Check movement

Ensure cylinder rail is free moving along transfer beam



Étape 7 - Add locking bolt

Add locking bolt to hold cylinder rail in position



Commentaires

Draft