R0015119 Mount Assemblies

Auteur avatarGareth Green | Dernière modification 18/01/2024 par Gareth Green en cours de rédaction

Introduction

Tools Required


Standard hex key set

Standard spanner set

Standard hss drill set

Standard tap set


Parts Required


D0004600 Outfeed Eject Bar

R0015342 Bench Assemble Outfeed Parts


Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 570 on all threaded pneumatic connections

Pen mark all bolts when finalised



Étape 2 - Mount cylinder assemblies

Attach 2 off pre built cylinder assemblies from R0015342 as shown using 4 off M6 x 20 socket caps and M6 heavy washers . Do not apply tension to these bolts as they will need adjusting


Étape 3 - Attach push eject bar

1 Attach D0004600 Outfeed Eject Bar x1 as shown using 4 off M6 x 25 socket caps. Apply only light pressure to these fixings


2 Ensure cylinder assemblies are retracted to the position shown


3 Finalise fixings ( 4 off 2 per cylinder assembly) shown to set correct pitching between cylinder assemblies


4 Set correct push bar position. Slacken indicated fixings and set push bar at its highest point as indicated


5 Finalise 4 off fixings that hold the push bar

Étape 4 - Finalise position of cylinder stroke

1 Measure 1 cylinder assembly at position shown


2 Adjust cylinder stroke of second assembly to replicate this first measurement


3 Double check all fixings have been Finalised including cylinder stroke lock nuts


Commentaires

Draft