Instructions for upgrade to material loaded assembly on Ecoline load rollers
Difficulté
Moyen
Durée
1 heure(s)
Introduction
Upgrade of load sensor For infeed table on Ecoline machines
Component list
A0001046 P Clip 6mm Steel / Rubber Liner x 2
D0010973 Material Loaded Sensor Plate x 1
E0001104 PreMade Cable: M8 Socket 4 Way Cable 5m x 1
E0001120 Sensor: Ultrasonic M8 20-150mm x 1
M0001053 Copper Tube 6mm x 4.4mm 10m Coil x 0.3
P0000046 Fitting: 'Y' Adaptor 6mm x 1
P0000069 Tube to tube fitting 6mm x 1
P0000160 Fitting: Flow Controller In Line 6mm x 1
Étape 1 - Remove original Assembly
Remove old material load assembly from machine. Held on by 2 off M6 socket caps indicated
2 Disconnect switch/sensor. Depending on variant fitted
either
Unscrew M8 plug connection to disconnect for sensor style
Or
Disconnect 2 off fork connections onto rear on switch
3 Disconnect blower
Étape 2 - Remove original Assembly
Disconnect switch/sensor.
Depending on variant fitted
either
Unscrew M8 plug connection to disconnect for sensor style
Or
Disconnect 2 off fork connections onto rear on switch
Étape 3 - Remove original Assembly
Disconnect blower feed to assembly
6mm pipe will be connected to remove assembly via push fit connections.
Remove pipe from connections
(may not be present on some machine variants )
Assembly can now be removed fully and disregarded
Étape 4 - Disconnect Sensor Cable.
Trace back cable fitted to old sensor and disconnect at connection box.
Étape 5 - Fit new Sensor
Fit new ultrasonic sensor E0001120 as shown using mounting block D0010973
Ensure cable E0001104 is fitted to sensor before mounting, and cable is fed through access point before finalising position of sensor
Étape 6 - Route new connection cable
Route new cable to connection point previously used to disconnect old sensor cable.
Étape 7 - Connect new sensor cable
Use attached drawing to connect new sensor to terminal rail in connection box
Draft
Français
English
Deutsch
Español
Italiano
Português