R0015311 Install and Align Datum rollers

Fitting and alignment details

Difficulté

Hard Difficile

Durée

3 hour(s) heure(s)

R0015311_Install_and_Align_Datum_rollers_Screenshot_2023-09-21_104723.png

Introduction

Tools required

Standard hex key set

2 meter straight edge

1 meter straight edge

12" engineers level

12" inch engineers square

Feeler gauge set

Parts Required

R0015297 Mount V Notch Datum rollers

Étape 1 - Unless otherwise stated

Use locktite 243 on all fasteners

Use loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Level Infeed datum rollers

1 Level On X axis using engineers level and adjusting grubscrews in indicated areas

2 Level from Rollers at indicated point. Adjust previous level points evenly to adjust level reading on rollers

3 Remove Middle roller and top blower

4 Use 300mm parallels to span rollers and engineers level to check and adjust Y axis level of rollers

Étape 3 - Level V notch datum rollers

en none 0 Draft