R0015119 Mount Assemblies

Assembly instructions

Difficulté

Medium Moyen

Durée

1 hour(s) heure(s)

R0015119_Mount_Assemblies_Screenshot_2023-08-30_145528.png

Introduction

Tools Required

Standard hex key set

Standard spanner set

Standard hss drill set

Standard tap set

Parts Required

D0004600 Outfeed Eject Bar

R0015342 Bench Assemble Outfeed Parts

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 570 on all threaded pneumatic connections

Pen mark all bolts when finalised

Étape 2 - Mount cylinder assemblies

Attach 2 off pre built cylinder assemblies from R0015342 as shown using 4 off M6 x 20 socket caps and M6 heavy washers . Do not apply tension to these bolts as they will need adjusting

Étape 3 - Attach push eject bar

1 Attach D0004600 Outfeed Eject Bar x1 as shown using 4 off M6 x 25 socket caps. Apply only light pressure to these fixings

2 Ensure cylinder assemblies are retracted to the position shown

3 Finalise fixings ( 4 off 2 per cylinder assembly) shown to set correct pitching between cylinder assemblies

4 Set correct push bar position. Slacken indicated fixings and set push bar at its highest point as indicated

5 Finalise 4 off fixings that hold the push bar

Étape 4 - Finalise position of cylinder stroke

1 Measure 1 cylinder assembly at position shown

2 Adjust cylinder stroke of second assembly to replicate this first measurement

3 Double check all fixings have been Finalised including cylinder stroke lock nuts

en none 0 Draft