R0002916 Install Machine Trunking

Fitment of trunking to main frame

Difficulté

Medium Moyen

Durée

3 hour(s) heure(s)

R0002916_Install_Machine_Trunking_Screenshot_2023-07-20_085632.png

Introduction

Tools Required

Standard hex key set

Standard spanner set

Standard HSS drill set

Standard tap set

Disc cutter

Parts Required

A0000068 Top lid gusset 50x50 bend 90° Armorduct x 4

A0001065 wire basket x 0.5

A0001061 Retainer: Wire Basket Cable Tray x 2

D0000301 M/C centre trunking front lower ZX4 x 1

D0000305 M/C centre trunking rear lower ZX4 x 1

D0000306 M/C centre trunking infeed lower (D8736) x 1

D0000307 M/C centre trunking infeed front offset x 1

D0000308 M/C centre trunking infeed rear offsetx 1

D0000309 M/C centre trunking outfeed front offset x 1

D0000313 M/C centre trunking outfeed rear offset x 1

D0000324 M/C centre trunking outfeed front upper x 1

D0000325 M/C centre trunking infeed front upper x 1

D0000326 M/C centre trunking front drop x 2

D0000327 M/C centre trunking outfeed lower x 1

D0000329 M/C centre trunking infeed rear end x 1

D0000694 M/C centre trunking outfeed rear end x 1

D0007996 Trunking support pillar x 1

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connection

Pen mark all fasteners to show finalised

Étape 2 - Clean threads

All holes on machining centre frame require threads cleaning to remove debris from coating process

Étape 3 - Mount lower trunking

Use the following parts

D0000301 M/C centre trunking front lower ZX4 x 1

D0000306 M/C centre trunking infeed lower (D8736) x 1

D0000305 M/C centre trunking rear lower ZX4 x 1

Add 6mm clearance holes to each piece of trunking as indicate to allow M5 fixings to be added to frame frame . Note hole indicated is pre drilled in trunking

Once clearance holes are added to trunking, position trunking as shown and drill and Tap M5 . Use M5 x 10 button sockets and penny washers to fix.

On the pre drilled hole use D0007996 Trunking support pillar x 1 to fix to frame

Once fixed, refit trunking lids to mounted sections

Étape 4 - Assemble upright 1

en none 0 Draft