R0015286 Bench Assemble X axis Components and Energy Chain

instructions for bench assembling x axis components

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

R0015028D_Bench_Assemble_X_Axis_components_and_Energy_chain_Screenshot_2023-06-12_123158.png

Introduction

Tools Required

Pipe cutters

Cable / pipe markers

Parts Required

A0001077 x 5

A0001070 x 1

E0000439 x 2

E00001237 x 1

Étape 1 - Unless otherwise stated

Use Loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all bolts to show finalised

Étape 2 - Assemble energy chain

Assemble energy chain using 152 links of A0001077 and 1 set of A0001070

1 Assemble moving end as shown. Ensure the indicated 4 links are rotated 180 degrees to the rest of the links on the energy chain

2 Assembly fixed end as shown

3 Quality check energy chain to make sure all linked are mounted in the correct orientation . Check that the 1st four are opposite and the remaining links are all orientated the same way

Étape 3 - Add identification to cables and pipes

Identify the following with markers

E000439 cable marked as X294

E0000439 cable marked as X291

E0001237 cable marked as SX

3 off 6mm black air pipes 11 meters long marked as

• 1311
• 1319
• 2419

Étape 4 - Add cable sand pipes to energy chain

Fit to energy chain ensuring no twists are present . All cables and pipes should run in straight limbs through the energy chain

1 Ensure the two plug ends and main servo end are exiting from the correct end of the energy chain

2 leave approximately 1 meter of pipes and cable exiting the indicated end

en none 0 Draft