R0015278 Mount Completed Assemblies

Instructions to mount completed assemblies to main frame

Difficulté

Medium Moyen

Durée

8 hour(s) heure(s)

R0015278_Mount_Completed_Assemblies_Screenshot_2023-07-14_093443.png

Introduction

Tools Required

Standard Hex key set

Standard spanner set

300 mm rule

1000mm rule

Parts Required

D0008288 Takeup Pad Left (D7339) (Wet/P F Matt) x 1

D0015583 Take Up Beam Joiner x 1

D0015598 Datum Flag: Saw Infeed x 1

D0015717 Energy Chain Angle Bracket Lower x 5

D0015718 Energy Chain Angle Bracket Upper x 2

D0015718B Energy Chain Angle Bracket Double Deck x 3

D0015720 Carriage Bracket x 1

D0015721 Energy Chain Tray Deep Long x 1

D0015723 Energy Chain Tray Shallow x 1

D0015724 Energy Chain Tray Deep x 2

D0015725 Energy Chain Tray Shallow Medium x 1

D0015742 Takeup Pad Right ZX5 x 1

D0015862 Energy Chain Tray Deep Long x 1

E0000336 Sensor: M8; 2mm, PNP N/O, M8 conn x 1

R0015011 Bench Assemble Gripper

R0015063 Bench Assemble Roller Tables

R0015096 Bench Assemble Transfer Drive Assembly

R0015101 Bench assembly take up assembly

R0015286 Bench Assemble X axis components and energy chain

Étape 1 - Unless otherwise stated

Use loctite 243 on all fasteners

Use Loctite 572 on all threaded pneumatic connections

Pen mark all fasteners to show finalised

Étape 2 - Mount pre built R0015063 Bench Assemble Roller Tables

Mount roller beds as indicated , using M8 x 30 socket caps and heavy M8 washers.

Do not apply adhesive to fasteners and only apply holding tension to fasteners

Étape 3 - Mount pre built R0015011 Bench Assemble Gripper

1 Mount Gripper assembly to carriage using 2 off M8 x 35 socket caps 2 off Mi8 x 2 5 socket caps and heavy M8 washers

2 Check and adjust parallel to ensure gripper is true to hepco beam both indicated measurements should be identical

Étape 4 - Mount Energy chain angle brackets Lower

Étape 5 -

Étape 6 -

Étape 7 -

Étape 8 -

Étape 9 -

Étape 10 -

en none 0 Draft