R0015257 Module C Pneumatic Tests

Instructions to pneumatically test build module

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

Introduction

Tools required

Parts Required

Étape 1 - Health and Safety

In this process pneumatic outputs will be tested in a non emergency stop environment

Ensure safe working practice is followed

• Ensure Machine test area is clear from personnel and all staff are aware of testing procedure commencing
• Ensure all Air connection lines are connected
• Ensure all walkways are not impeded by trailing pipes/leads
• Ensure all mechanical assemblies are at a sufficient stage for testing

Étape 2 - Check all connections are made

• Check all valve bank ports are either connected or blanked off
• Check all mains feed pipes are connected or isolated
• Check all regulators are regulated to minimum setting
• Check all air flow control valves on cylinders and blow lines are set to mid range adjustment

Étape 3 - Connect air feed

Connect air feed to mains 12mm feed pipe using pcl coupling and 12mmm push fit adapter

Étape 4 - check for air leaks

Investigate any air leaks and resolve

Étape 5 - Test valve bank outputs

Each valve on the Valve bank can be manually overridden to activate the output.

When each valve is individually

Étape 6 -

Étape 7 -

Étape 8 -

Étape 9 -

Étape 10 -

Étape 11 -

en none 0 Draft