R0015007 Bench Assemble Roller Tables Machining Outfeed

Instructions to bench assemble roller beds

Difficulté

Medium Moyen

Durée

6 hour(s) heure(s)

R0015007_Bench_Assemble_Roller_Tables_Machining_Outfeed_Screenshot_2023-06-06_134253.png

Introduction

Tools Required

Parts Required

Étape 1 - Assemble Cylinder assembly

13 off

1 Fit 2 off P0001198 fittings to cylinder P0001110

2 Fit spherical bearing P0000049 to cylinder end , Do not add final tension to the nut

Étape 2 - Check for rework

13 off

Check part D00150001 has been supplied to new specification

Check indicated hole, should measure 8.2mm. If not open up with hand drill

Drawing change requested 06/06/23 to amend from 8mm to 8.2mm

Étape 3 - Check for rework of following parts

1 D0015006B indicated holes should measure as shown. Rework by hand if issued old spec

ECR raised 06/06/23

2 D0015002 rod end shaft . Check fit in P0000049 spherical bearing . Polish down diameter to allow shaft to pass through.

ECR raised 06/06.23 to improve tolerance of shaft to allow better fitment

Étape 4 - Fit bushes and mount cylinder

13 off

1 Combine D0015481 shaft and B0001220 spacer as shown to mount cylinder to bracket. Use M6 x 12 socket caps and A form washers to fasten

2 Fit 2 off B0001103 bushes to D0015006B

Étape 5 - Combine support arm and roller bracket

13 off

1 Fit 2 off D0015010 spacers, 1 off d0015002 shaft through spherical bearing and fix with 2 off m6 X 12 socket caps and A form washers

2 Fit 1 0ff D0015603 pivot shaft with 2 off M6 x 12 socket caps and A Form washers

Étape 6 - Prepare M3 holes

1 off only and mark for later Reference

1 Tap 2 off indicated holes M3

2 Tap 2 off indicated holes M3

Étape 7 -

Étape 8 -

Étape 9 -

Étape 10 -

Étape 11 -

en none 0 Draft