R0015308 Bench assemble connection boxes

Pre assembly of connection boxes for ring spindles

Difficulté

Medium Moyen

Durée

2 hour(s) heure(s)

Bench_assemble_connection_boxes_Screenshot_75.png

Introduction

Tools Required

Standard hex key set

3.3mm drill bit

Step drill

Drill

Small countersink

Parts Required

P0000439 Valve x 12

P0001092 4mm m7 fitting x 24

P0000455 valve lead x 12

P0000040 M7 6mm air fitting x 12

P0000036 M7 6mm elbow x 24

D0007618E connection box x 8

A0000152 blank x 16

Étape 1 - Assemble control valves

1 Assemble P0000439 valves as shown (12 off)

2 Ensure fittings have flats lined up for ease of installation

3 Attach P0000455 lead to valve (12 off)

Étape 2 - Check connection boxes and prepare cable entry

1 Check that connection boxes have had debris removed from coating process. Tap holes to clean if required . This applies to all tapped holes on the connection box

2 Fit 16 off A0000152 blanks to front section of connection box ( 2 per box)

3 Prepare 4 off boxes as shown in picture,using step drill for larger hole. Counter sink to tidy

4 Prepare 4 boxes as shown in picture, using step drill for larger hole. Counter sink to tidy

en none 0 Draft