R0015295 Finalise wiring loom for Rotary head

correct routing of cables ready for connection boxes

Difficulté

Medium Moyen

Durée

1 hour(s) heure(s)

Finalise_wiring_loom_for_Rotary_head_Screenshot_2023-05-31_145134.png

Introduction

Tools required

Étape 1 - Wiring loom positioning Ethercat control

Cables must be adjusted between each spindle to ensure the cable lengths are correct .

1 Start at cable point between 6 and 5 . Start with the light green ethercat cable with the right angle plug. Adjust so that 200mm is past the end of the spindle plate . See picture for detail.

2 Move to the next spindle connection between 5 and 4 and adjust the new right angled ethercat cable to match the length of the previous adjusted cable

3 Repeat this process working your way around the spindles to set all ethercat cables

Étape 2 - Wiring loom positioning Ethercat power

1 Start at cable point between 6 and 5 . Adjust black power cable to 200mm from edge of plate. See picture for details

2 Move to the next spindle connection between 5 and 4 and adjust the new black power cable to match the length of the previous adjusted cable

3 Repeat this process working your way around the spindles to set all power cables

Étape 3 - Wiring loom positioning 300hz power

en none 0 Draft