R0000711 Rotary Base Assembly REV2

Assembly instructions for installation of main rotary drive ring

Difficulté

Hard Difficile

Durée

2 hour(s) heure(s)

R0000711_Rotary_Base_Assembly_Screenshot_2023-05-26_095708.png

Introduction

Detailed steps to correctly install rotary gear and journals

Checks for correct installation of oil feed system

Tolerance limits and requirements

Parts required

D0006423-2mc Drive ring x 1

D0007651 Face plate x 1

Étape 1 - Quality Check Drive ring

Rotary drive ring needs checking before fitment.

1. Check teeth for burrs, damage and debris. Use compressed air to clean all areas
2. V edge should be checked for damage. Check entire circumference with fingers to identify any damage, lumps or high low spots
3. Check drive ring has been countersunk in the shown area

Étape 2 - Prepare Faceplate For assembly

Check that Holes indicated (1) are countersunk the same as holes indicated (2 ). If not , countersink to correct

3. Clean all holes with compressed air

Thoroughly clean faceplate with solvent

Étape 3 -

en none 0 Draft