Stuertz Infeed Table Measurements

Critical measurements and settings for an Autoflow infeed table

Method

...Make sure the GX axis is scaled correctly before starting any measurements

...Ensure the infeed is set at the correct distance from the machining centre (500mm between feet centreline

• Use the gripper arm as the measuring stick. The datum must be set so that zero is the spindle centreline.
• The measure point is when the gripper nose switch is depressed

Measurement	Description	A2027 Value	Photo
Machining Centre to Infeed spacing	DDistance between centrelines of feet	500
Zero Datum	Centreline of spindles	0
measureStartPosX	Measuring start position Should be so that measure sensor is on machining centre side of the profile load fence	-880
infeedToZeroX	Distance from zero to profile load fence	600
GX Axis Max position	Maximum travel on GX Axis After datum, press estop and manually move to end of travel Note the value and subtract 10mm	7255
GX Move After Datum	Ideally set to max profile length+infeedZeroToX+100 ...Must not exceed GX Max pos	6500+600+100 =7200

en none 0

Draft