Saw Y Drive Calculations

Technical Details of the Saw Y Drive system

Y Drive, Y Notch, ZX5

Overview

The Saw Y drive system has been developed as a modification to the standard stuga saw module to allow the system to cut Y notch shapes. A Y notch is half of a V notch and consists of a square cut and mitre cut together. The depth of the mitre cut will produce a V notch of the correct depth when the pieces are welded together.

The system works by using the centralise system, normally used for arrow head centralisation. Instead of cutting a 45 degree then 135 degree cut, the system cuts 90 then 45 (or 135) cuts, but importantly, the system is able to offset the centre point of this cut to vary the depth.

Using this system has two distinct advantages

1. The Y notch is cut in one operation improving the reliability of the accuracy of the cut
2. The start point is the centralised centreline of the profile, which means the depth is directly related to the physical profile width, which helps accuracy if the profile is out of tolerance

Calculations

The SY axis datum zero point is the centreline of the profile.

Positive SY Axis direction is from this centreline towards the rear of the machine.

Negative is away from the backfence.

The following diagram shows the Y notch calculations for a profile of width w

Example

For a 34.5mm deep Front Y notch in 70mm profile: en none 0

Draft