Recovery of Bar Queue following winMulti Crash

Recovering the bar queue to match the number of bars on transfer table following a crash on winMulti

Difficulté

Very easy Très facile

Durée

2 minute(s) minute(s)

winMulti, Crash, bar queue

Introduction

There have been cases of software crashing on the Stuga front end at the exact point when a bar is created for the saw queue.

The bar is physically ejected on to the transfer table, but the software crashed before the bar enters the software queue.

This can lead to confusion for the operator and put the bar queue out of sync, which can lead to wasted profile

Étape 1 - Check the bar queue on the saw screen

en none 0 Draft