Modification necessary to allow 90mm tall profile Z sections to be handles by Stuga Machines Liniar LCW9022

Modification necessary to allow 90mm tall profile Z sections to be handles by Stuga Machines Liniar LCW9022

Sommaire

Sawing Clamps - ZX5

The side clamp block D0015174 are modified to allow a roller at a higher position to coincide with the top edge of the 90mm profile

This is a permanent change to this block, and the additional rollers can be fitted as an optional extra - kit is

R0019222 includes the fence

or R0019222B if the fence is already modified

A larger Z block D0015178B is also added to this kit to prevent potential pivot points on the taller Z section.

During testing the DFR operation could not complete the plunge because the spindle plunge bracket interferes with the bottom edge of the profile

There is no way around this issue with the tool depth set at the standard positions (level with inside of the ring)

Solution:

Increase the plunge length of a specific tool
Create a special drainage operation for DFR on LCW9022
Create a variable for the flowops editor to allow a tool depth offset on screen when this tool is selected

...A special tool number of 9 is used in this instance so it does not affect the programming depth of all other 5mm drainage tools

en none 0

Draft