R0015305A Install Wiring loom for Rotary Ring

Installation of wiring loom and captivating spindle bases

Difficulté

Hard Difficile

Durée

4 hour(s) heure(s)

R0015305_Install_Wiring_loom_for_Rotary_Ring_Screenshot_2024-09-24_161352.png

Introduction

Tools Required

Standard hex key set

Ball pein hammer

6mm drift/punch

Drill driver

6mm hex drill attachment

Parts Required

D00000291 spindle plate x 8

M0000025 Ident numbers x 1

D0007703 r stop pin x 1

D0007990 cylinder anchor x 1

D0007777 Trunking backplate x 2

Étape 1 - Quality

All bolts to have Loctite 243 adhesive applied unless otherwise stated

All bolts to be pen marked once adhesive applied and correct tension added

Étape 2 - Quality Check

Check D0000291 spindle base has M4 hole tapped all the way through the plate. Rework if not

Étape 3 - Start Wiring loom installation

1 Segregate cables and 6mm blue pipe as shown

2 Use pre made cable identified as 6 and 7 and lay between 2 points shown

Étape 4 - Fit spindle plate 6

1 Fit D0000291 spindle plate and lightly secure with 2 off M8 x 25 socket caps in opposing corners

2 Fit M0000025 number ident (number 6)

Étape 5 - Fit Spindle plate 5

1 Retrieve pre marked ethercat cable marked SP5-SP6

2 Retrieve pre marked power cable marked 5-6

3 Lay both cables into chamber to the left of previous fitted plate

Ensure SP5 and 5 exit to left

Ensure SP6 and 6 exit to the right

4 Fit D0000291 spindle plate and lightly secure with 2 off M8 x 25 socket caps

5 Fit M0000025 ident number to spindle plate (number 5)

Étape 6 - Fit Spindle plate 4

1 Retrieve pre marked ethercat cable marked SP4-SP5

2 Retrieve pre marked power cable marked 4-5

3 Lay both cables into chamber to the left of previous fitted plate

Ensure SP4 and 4 exit to left

Ensure SP5 and 5 exit to the right

4 Fit D0000291 spindle plate and lightly secure with 2 off M8 x 25 socket caps

5 Fit M0000025 ident number to spindle plate (number 4)

en none 0 Draft