ACEpc Installing netedit with NetSetGo disk

Using a NetSetGo disk to reformat an ACEpc hard drive and install all the correct software to enable IP address networking

Difficulté

Very easy Très facile

Durée

5 minute(s) minute(s)

ACEpc, netsetgo, networking ACE_PC_Re-Flash_20190827_142747.jpg

Introduction

This procedure will completely overwrite any data on the hard drive of the ACEpc.

This is not a problem on a flowline where the data resides on the main MH hard drive in a shared directory c:\saw.

If this process is to be carried out on a standalone saw or router, make sure the data is backed up first.

Étape 1 - Insert disk (Power off)

Étape 2 - Power On

Étape 3 - Proceed with format Y

Volume label [enter]

This will format the hard drive and then copy all necessary network software as a ZIP file to the hard drive and then inflate it.

Étape 4 - Run NetEdit from command prompt

At DOS prompt, ensure you are on drive C: by typing

c:

And press enter

type

netedit

And press enter

Étape 5 - Set the saw name

en none 0 Draft